CARRIER CHAIN LUG OFFSETS TOO CLOSE

The Offset values for the Carrier Chain Master and Slave are too close.  The Carrier Chain Master and Slave values must be separated by at least 3/4" (value >= 75).  To correct this problem, do the following:

1) Press Maintenance Button
2) Press Servo System Button
3) Examine the Inside and Outside Left Hand Carrier Chain values.  
4) Values for these two items need to be changed so that the difference is more than 75.
5) Examine the Inside and Outside Right Hand Carrier Chain values.  
6) Values for these two items need to be changed so that the difference is more than 75.